Applying Vinyl Siding Starter Strip

This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.

Applying vinyl siding starter strip.

Snap each length of siding in place so that its bottom lip hooks under the starter strip. Position starter strip with the top edge of chalk line and allow room for corner posts. Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip. Cap the corner posts.

Nail the starter strip to the siding aligning the top of the strip with the chalk line. Determine the lowest point of the wall that will be sided. Mice bees and all sorts of other critters love making their home inside vinyl corner posts. 13 simple vinyl siding installation tips use the wider starter strip.

Attach j channel trim strips around windows and doors and along the eaves. Hold a tape measure against the exterior wall and travel. Slide it into the corner and nail it every 16 in. Nail vertical vinyl corners to the corners of the house making sure they are plumb.

From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Insulation for vinyl siding 1. Staret strip secures the first course of siding to the home.

Pull up as. Be sure to center the nails in their slots to. Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape. This is where the new siding will begin.

Find the lowest corner of the old siding or sheathing on the house. In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level. Partly drive a nail 11 2 in. Locate the lowest possible corner that has sheathing.

How to install a vinyl siding starter strip step 1. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding. The bottom of the starter strip the part the bottom panel hooks on to should be at least. Vinyl siding starter strips.